Renesas SH7041 Series, Hardware Manual, Page: 600 / 923

562
Table 15.7 A/D Conversion Times
CKS = 0 CKS = 1
Time Symbol Min Typ Max Min Typ Max
A/D conversion start
delay time t
D
1.5 1.5 1.5 1.5 1.5 1.5
Input sampling time t
SPL
20 20 20 40 40 40
A/D conversion time t
CONV
42.5 42.5 42.5 82.5 82.5 82.5
Notes: 1. Unit: states
2. Table entries are for when ADST = 1. If 200 states have not elapsed since the PWR bit
has been set, no conversions are done until after those 200 states have occurred.
When PWR = 0, add 200 states to the first A/D conversion start delay time. When
continuously executing conversion, tcp for the second time and following is 20 cycle
when CKS=0 and 40 cycle when CKS=1.
The CKS bit of the ADCSR is the operation time t
CONV
, but set so that this is 2 µs or greater. Table
15.8 shows the operating frequency and CKS bit settings.
Table 15.8 Operating Frequency and CKS Bit Settings
Conversion Time
Minimum Conversion Time (µs)
CKS (States) 28 MHz 20 MHz 16 MHz 10 MHz 8 MHz
0 42.5 — 2.1 2.6 4.3 5.3
1 82.5 2.9 4.2 5.0 8.3 10.3
Note: The indication “—” means the setting is not available.
15.5 Interrupts
The high speed A/D converter generates an A/D conversion end interrupt (ADI) upon completion
of A/D conversions. The ADI interrupt request can be enabled or disabled by the ADIE bit of the
ADCSR.
The DTC or DMAC can be activated by ADI interrupts. When converted data is read by the DTC
or DMAC upon an ADI interrupt, consecutive conversions can be done without software
responsibility.
Table 15.9 lists the high speed A/D converter interrupt sources.
During scan mode, if the ADIE bit is set to 1, A/D conversion is temporarily suspended
immediately when the ADF flag is set to 1. A/D conversion is restarted when the ADF flag is
cleared to 0.