Renesas SH7041 Series, Hardware Manual, Page: 256 / 923

218
Table 11.2 DMAC Registers (cont)
Chan-
nel
Name
Abbrevi-
ation
R/W
Initial
Value
Address
Register
Size Access
Size
2
(cont) DMA transfer count
register 2 DMATCR2 R/W Undefined H'FFFF86E8 32 bit 16, 32
*
3
DMA channel control
register 2 CHCR2 R/W
*
1
H'00000000 H'FFFF86EC 32 bit 16, 32
*
2
3 DMA source address
register 3 SAR3 R/W Undefined H'FFFF86F0 32 bit 16, 32
*
2
DMA destination
address register 3 DAR3 R/W Undefined H'FFFF86F4 32 bit 16, 32
*
2
DMA transfer count
register 3 DMATCR3 R/W Undefined H'FFFF86F8 32 bit 16, 32
*
3
DMA channel control
register 3 CHCR3 R/W
*
1
H'00000000 H'FFFF86FC 32 bit 16, 32
*
2
Shared DMA operation
register
DMAOR R/W
*
1
H'0000 H'FFFF86B0 16 bit 16, 32
*
4
Notes: Do not attempt to access an empty address. If an access is attemped, the system
operation is not guarenteed.
*
1 Write 0 after reading 1 in bit 1 of CHCR0–CHCR3 and in bits 1 and 2 of the DMAOR to
clear flags. No other writes are allowed.
*
2 For 16-bit access of SAR0–SAR3, DAR0–DAR3, and CHCR0–CHCR3, the 16-bit value
on the side not accessed is held.
*
3 DMATCR has a 24-bit configuration: bits 0–23. Writing to the upper 8 bits (bits 24–31)
is invalid, and these bits always read 0.
*
4 Do not make 32-bit access for DMAOR.
11.2 Register Descriptions
11.2.1 DMA Source Address Registers 0–3 (SAR0–SAR3)
DMA source address registers 0–3 (SAR0–SAR3) are 32-bit read/write registers that specify the
source address of a DMA transfer. These registers have a count function, and during a DMA
transfer, they indicate the next source address. In single-address mode, SAR values are ignored
when a device with DACK has been specified as the transfer source.
Specify a 16-bit or 32-bit boundary address when doing 16-bit or 32-bit data transfers. Operation
cannot be guaranteed on any other addresses.
The initial value after power-on resets or in software standby mode is undefined. These registers
are not initialized with manual reset.