Renesas SH7041 Series, Hardware Manual, Page: 514 / 923

476
14.2.6 Serial Control Register (SCR)
The serial control register (SCR) operates the SCI transmitter/receiver, selects the serial clock
output in the asynchronous mode, enables/disables interrupt requests, and selects the
transmit/receive clock source. The CPU can always read and write the SCR. The SCR is initialized
to H'00 by a power-on reset or in standby mode. Manual reset does not initialize SCR.
Bit: 7 6 5 4 3 2 1 0
TIE RIE TE RE MPIE TEIE CKE1 CKE0
Initial value: 0 0 0 0 0 0 0 0
R/W: R/W R/W R/W R/W R/W R/W R/W R/W
•
Bit 7—Transmit Interrupt Enable (TIE): Enables or disables the transmit-data-empty interrupt
(TxI) requested when the transmit data register empty bit (TDRE) in the serial status register
(SSR) is set to 1 by transfer of serial transmit data from the TDR to the TSR.
Bit 7: TIE Description
0 Transmit-data-empty interrupt request (TxI) is disabled (initial value).
The TxI interrupt request can be cleared by reading TDRE after it has
been set to 1, then clearing TDRE to 0, or by clearing TIE to 0.
1 Transmit-data-empty interrupt request (TxI) is enabled
•
Bit 6—Receive Interrupt Enable (RIE): Enables or disables the receive-data-full interrupt (RxI)
requested when the receive data register full bit (RDRF) in the serial status register (SSR) is set
to 1 by transfer of serial receive data from the RSR to the RDR. It also enables or disables
receive-error interrupt (ERI) requests.
Bit 6: RIE Description
0 Receive-data-full interrupt (RxI) and receive-error interrupt (ERI)
requests are disabled (initial value). RxI and ERI interrupt requests can
be cleared by reading the RDRF flag or error flag (FER, PER, or ORER)
after it has been set to 1, then clearing the flag to 0, or by clearing RIE
to 0.
1 Receive-data-full interrupt (RxI) and receive-error interrupt (ERI)
requests are enabled.