Renesas SH7041 Series, Hardware Manual, Page: 322 / 923

284
Channels 0, 3, 4:
Bit 7:
CCLR2 Bit 6:
CCLR1 Bit 5:
CCLR0
Description
0 0 0 TCNT clear disabled (initial value)
1 TCNT is cleared by TGRA compare-match or input capture
1 0 TCNT is cleared by TGRB compare-match or input capture
1 Synchronizing clear: TCNT is cleared in synchronization with clear of
other channel counters operating in sync.
*
1
1 0 0 TCNT clear disabled
1 TCNT is cleared by TGRC compare-match or input capture
*
2
1 0 TCNT is cleared by TGRD compare-match or input capture
*
2
1 Synchronizing clear: TCNT is cleared in synchronization with clear of
other channel counters operating in sync
*
1
Notes: * 1 Setting the SYNC bit of the TSYR to 1 sets the synchronization.
*
2 When TGRC or TGRD are functioning as buffer registers, TCNT is not cleared because
the buffer registers have priority and compare-match/input captures do not occur.
Channels 1, 2:
Bit 7:
Reserved
*
1
Bit 6:
CCLR1 Bit 5:
CCLR0
Description
0 0 0 TCNT clear disabled (initial value)
1 TCNT is cleared by TGRA compare-match or input capture
1 0 TCNT is cleared by TGRB compare-match or input capture
1 Synchronizing clear: TCNT is cleared in synchronization with
clear of other channel counters operating in sync
*
2
Notes:
*
1 The bit 7 of channels 1 and 2 is reserved. It always reads 0, and cannot be modified.
* 2 Setting the SYNC bit of the TSYR to 1 sets the synchronization.
•
Bits 4–3—Clock Edge 1, 0 (CKEG1 and CKEG0): CKEG1 and CKEG0 select the input clock
edges. When counting is done on both edges of the internal clock the input clock frequency
becomes 1/2 (Example: both edges of
φ/4
= rising edge of
φ/2
). When phase count mode is
used with channels 1, 2, these settings are ignored, as the phase count mode settings have
priority.