Renesas SH7041 Series, Hardware Manual, Page: 451 / 923

413
•
In PWM mode 2, since a waveform is not output to the cycle register pin, setting TIOR will
not initialize the pins. If initialization is required, carry it out in normal mode, then switch to
PWM mode 2.
•
In normal mode or PWM mode 2, if TGRC and TGRD operate as buffer registers, setting
TIOR will not initialize the buffer register pins. If initialization is required, clear buffer mode,
carry out initialization, then set buffer mode again.
•
In PWM mode 1, if either TGRC or TGRD operates as a buffer register, setting TIOR will not
initialize the TGRC pin. To initialize the TGRC pin, clear buffer mode, carry out initialization,
then set buffer mode again.
•
When making a transition to a mode (CPWM, RPWM) in which the pin output level is selected
by the timer output control register (TOCR) setting, switch to normal mode and perform
initialization with TIOR, then restore TIOR to its initial value, and temporarily disable channel
3 and 4 output with the timer output master enable register (TOER). Then operate the unit in
accordance with the mode setting procedure (TOCR setting, TMDR setting, TOER setting).
Pin initialization procedures are described below for the numbered combinations in table 12.19.
The active level is assumed to be low.
Note: Channel number is substituted for * indicated in this article.