Raymarine c125, Installation And Operation Instructions Manual

Page: 292 / 464

20.1 Data application overview
The Data application enables you to view data
generated by the multifunction display or data that is
available on your system.
Data can be obtained from devices connected using
SeaTalk
hs , SeaTalk ng or NMEA protocols.
Pre-configured datapages
The default datapage configuration is dependant
upon the boat type selected during the initial set-up
wizard.
Each datapage consists of a number of 'cells', that
display the information.
Default datapage configuration is shown below:
Motor vessel Sailing vessel
Page
number Page Page
number Page
1/6
Engine
1/5
Engine
2/6 Navigation 2/5 Navigation
3/6 Environment 3/5 Sailing
4/6 Fishing 4/5 Environment
5/6 Fuel 5/5 Rolling road
6/6 Rolling road
Note: Datapage selection is a local setting, and
therefore only affects the individual display that
you are currently using. It does not affect any
networked displays.
Engine page
The Engine page is available for all boat types. The
dials and type of data displayed is dependent on the
Number of engines set in the Boat Details settings.
Important: The relevant engine data must be
available on your network for the Engine page to
show engine data.
Example — engine page for 2 engine vessel.
D13058-1
5
7
6
1 4 2 3
8 9 1 0 1 1 1 2
1. Port engine combined oil pressure and coolant
temperature dial
2. Total fuel
3. Engine Economy total
4. Starboard engine combined oil pressure and
coolant temperature dial
5. Port engine RPM dial
6. Starboard engine RPM dial
7. Trim tabs
8. SOG
9. Port alternator
10. Rudder bar
11. Starboard alternator
12. Depth
Navigation page
The Navigation page is available for all boat types.
D13062-1
5
6
7
8
1 4 2 3
1 0 1 1 9
1. Heading
2. Rolling road
3. Target waypoint
4. Waypoint ETA (Estimated time of arrival)
5. Heading to target waypoint
6. Distance to target waypoint
7. COG
8. SOG
9. VMG to waypoint
10. Rudder bar
11. Depth
292 a Series / c Series / e Series