Raymarine c125, Installation And Operation Instructions Manual

Page: 455 / 464

1
3
5
2
4
6
D12739-1
1 Toggle switch.
2 Rotary (multi-state) switch.
3 Position control switch.
4 Momentary switch.
5 Data item (dial gauge).
6
Data item (tank level).
Using the switches on a Touchscreen
This only applies to HybridTouch displays.
From the switch panel application:
1.
Toggle switch — Select the switch to switch on
or off.
2. Rotary control — Selecting the rotary control
will cycle through its available states.
3. Position Control — Select and hold on a
direction to move.
4. Momentary switch — Select the switch to
activate.
5. Dimmer switch — Select and then drag the
control to adjust the value.
Using the switches
From the switch panel application:
1. Use the
Joystick to highlight the relevant switch.
2. Toggle switch — Press Ok to switch on or off.
3. Rotary control — Pressing Ok will cycle through
its available states.
4. Position Control — Press Ok and use the
Joystick to move direction.
5. Momentary switch — Press Ok to activate.
6. Dimmer switch — Press Ok on the switch and
use the Rotary Control to adjust the value, then
select back to exit adjust mode.
Resetting a tripped circuit
When a circuit is tripped a pop-up message will be
displayed on-screen providing details of the tripped
circuit and options, the circuit will also be identified
as tripped in the switch panel pages.
1. With a tripped circuit pop-up message displayed
select Reset . to reset the tripped circuit, or
2. Select the switch on a switch panel page to reset
the tripped switch.
Note: Performing multiple resets risks causing
damage to your system so if a trip persists check
the main circuits.
Switch panel application
455