Raymarine c125, Installation And Operation Instructions Manual

Page: 64 / 464

4.11 IP Camera connections
You can connect IP cameras to your multifunction
display.
Compatible IP cameras must be able to be
configured to:
• automatically assign an IP address via DHCP
prior to connecting to your multifunction display
or network.
• allow unauthenticated, anonymous ONVIF access.
Please refer to the instructions supplied with your IP
camera for configuration details.
Note: The connection panel on your product may
look slightly different from that shown, depending
on variant. The network connection method
remains the same for all products featuring RayNet
connectors.
IP camera(s) can be connected to the SeaTalk hs
RayNet connector on your multifunction display.
D12592-4
1
3
4
2
Item Description
1 Multifunction display rear connector panel
2 CAM200IP
3 RayNet to RJ45 adaptor cable (A62360 / A80151
/ A80159)
4 Ethernet coupler (R32142)
You can also connect multiple IP cameras via the
SeaTalk
hs network
D12593-4
1
4
3
2
5
5
5
5
3 3
3
4
4
4
Item Description
1 Multifunction display
2 Raymarine network switch
3 RayNet to RJ45 adaptor cables (A62360 /
A80151 / A80159)
4 Ethernet couplers (R32142)
5
CAM200IP s
Note: a, c and e Series multifunction displays do
not provide power over ethernet (PoE); Connected
cameras must have their own power supply.
Tip If your IP camera(s) are not detected by your
multifunction display, try power cycling the IP
camera(s) whilst leaving your multifunction display
powered up.
IP camera guidance
Raymarine ® MFD s are capable of displaying IP
camera feeds. Whilst third-party IP cameras may
work,
Raymarine ® highly recommends only using
Raymarine ® IP cameras such as the CAM200IP .
As guidance any third-party IP camera must conform
to the following:
• The camera must support H.264 compression and
RTSP (Real time Streaming Protocol).
• The camera must be ONVIF compliant
• The camera must be capable of and be setup to
allow unauthenticated anonymous access
• The camera must be capable of and be setup to
assign an IP address automatically via DHCP
• The camera resolution must be set to no higher
than 720p
The camera settings must be checked and if
necessary adjusted using a PC and the software
supplied with the camera, prior to adding the camera
to the
SeaTalk hs network.
64 a Series / c Series / e Series