Raritan PX3-3000 series, User Manual

Page: 765 / 875

Appendix H: LDAP Configuration Illustration
741
Step C. Configure LDAP Authentication on the PX3 Device
You must enable and set up LDAP authentication properly on the PX3
device to use external authentication.
In the illustration, we assume:

The DNS server settings have been configured properly. See
Wired
Network Settings (on page 252) and Role of a DNS Server (on page
806).

The AD server's domain name is
techadssl.com, and its IP address is
192.168.56.3.

The AD protocol is NOT encrypted over TLS.

The AD server uses the default TCP port 389.

Anonymous bind is used.
To configure LDAP authentication:
1. Choose Device Settings > Security > Authentication.
2. In the LDAP Servers section, click New to add an LDAP/LDAPS
server.
3. Provide the PX3 with the information about the AD server.
Field/setting Do this...
IP Address / Hostname Type the domain name
techadssl.com
or IP address
192.168.56.3
.

Without the encryption enabled, you can type either the domain
name or IP address in this field, but you must type the fully
qualified domain name if the encryption is enabled.
Copy settings from
existing LDAP server Leave the checkbox deselected unless the new LDAP server's
settings are similar to any existing LDAP settings.
Type of LDAP Server Select "Microsoft Active Directory."
Security Select "None" since the TLS encryption is not applied in this
example.
Port (None/StartTLS) Ensure the field is set to
389
.
Port (TLS),
CA Certificate
Skip the two fields since the TLS encryption is not enabled.
Anonymous Bind Select this checkbox because anonymous bind is used.