Raritan PX3-3000 series, User Manual

Page: 518 / 875

Chapter 8: Using the Command Line Interface
494
Setting the IPv4 Configuration Mode
This command determines the IP configuration mode.
config:# network ipv4 interface <ETH> configMethod <mode>
Variables:

<ETH> is one of the network interfaces: ethernet (or ETH1/ETH2),
wireless, or bridge. Note that you must choose/configure the bridge
interface if your PX3 is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET (or
ETH1/ETH2) and WIRELESS interfaces do NOT function.
Interface Description
ethernet (PX3) Determine the IPv4 configuration mode of the
ETHERNET interface (that is, wired networking).
eth1
(PX3-iX7)
Determine the IPv4 configuration mode of the
ETH1 interface (wired networking).
eth2
(PX3-iX7)
Determine the IPv4 configuration mode of the
ETH2 interface (wired networking).
wireless Determine the IPv4 configuration mode of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv4 configuration mode of the
BRIDGE interface (that is, bridging mode).

<mode> is one of the modes:
dhcp or static.
Mode Description
dhcp The IPv4 configuration mode is set to DHCP.
static The IPv4 configuration mode is set to static IP
address.