Chapter 5: Introduction to PDU Components
127
To replace a fuse on 1U PDUs:
1.
Disconnect the PDU's power cord from the power source.
2.
Remove the desired fuse from the PDU's fuse carrier using a flat
screwdriver.
a.
Rotate the fuse knob counterclockwise until its slot is inclined to
45 degrees.
b.
Take this knob out of the fuse carrier.
3.
Remove the original fuse from this knob, and insert either end of a
new one into the knob. Make sure the new fuse's rating is the same
as the original one.
Number
Description
Fuse knob
Fuse
4.
Install this knob along with the new fuse into the fuse carrier using a
flat screwdriver.
a.
Have this knob's slot inclined 45 degrees when inserting the
knob into the fuse carrier.
b.
Gently push this knob into the fuse carrier and then rotate it
clockwise until its slot is horizontal.
Summary of Contents for PX3-3000 series
