Raritan PX3-3000 series, User Manual, Page: 747 / 875

Appendix G: Old PX3 Character LCD Display
723

W is displayed for the power reading. W means Watt.
4. To show the unbalanced load and active power of this 3-phase outlet,
do the following:
a. Switch to the current reading of L1.
b. Press the Down button until '%' or 'W' is displayed to the right of
the display. Make sure NONE of the lines (L1, L2, L3, L1-L2,
L2-L3 or L3-L1) is displayed at the bottom of the display.

Unbalanced load - % is displayed for the unbalanced current
value.

Active power - W is displayed for the power reading. W
means Watt.
Inlet Information
The Inlet mode is displayed as "INLET" on the LCD display. Below
illustrates the inlet information shown on the LCD display.
Section Example information
The selected target is INLET 1.
This inlet's L1 current reading is 23 amps.
The selected inlet line is L1.
The word "MASTER" indicates the PX3 is the master
device in a cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: As of release 3.3.10, the "MASTER/SLAVE"
information is no longer available in the Bridging mode,
but remains available in the Port Forwarding mode.
The measurement unit is A (ampere).
To display an inlet's information:
1. Press the MODE button until the term "INLET" is displayed.