Raritan PX3-3000 series, User Manual

Page: 752 / 875

Appendix G: Old PX3 Character LCD Display
728
3. The MAC address is displayed as "M:XX", where XX are two digits of
the MAC address. The LCD will cycle through the MAC address from
the first two digits to the final two.
For example, if the MAC address is 00:0d:5d:03:5E:1A, the LCD
display shows the following information one after another:
M 00 --> M:0d --> M:5d --> M:03 --> M:5E --> M:1A
Note that 'M' is NOT followed by the colon symbol when showing the
first two digits of the MAC address.
Outlet Switching
This section applies to outlet-switching capable models only.
You can turn on or off any outlet using the LCD display in the outlet
switching mode. To do this, you must first enable the front panel outlet
control function. See
Miscellaneous (on page 384).
To turn on or off an outlet:
1. Press the MODE button until the LCD display enters the outlet
switching mode, which is indicated by the power state of OUTLET 1.

When outlet 1 has been powered on, the word 'on' is displayed as
shown below.

When outlet 1 has been powered off, the word "oFF" is displayed
instead.
2. Press the Up or Down button to select the desired outlet. The
selected outlet's number is displayed at the top of the LCD display.
3. Press the FUNC button to perform the outlet switching operation.
The LCD display cycles between two messages as shown in the two
diagrams below. In the following diagrams, X represents the
selected outlet's number.