Forum Gateway 560 Installation
96
Installing the Central Control Module
A Forum Gateway 560 comes with the central control module installed.
Should you need to exchange the central control module, proceed as follows:
DANGER!
Hazardous voltages inside the device!
1.
Unplug all of the mains cables of the Forum Gateway 560 to disconnect
the device from the mains supply.
The central control module must not be installed if the
Forum Gateway 560 is switched on! Refer to
2.
Remove the screws with which the central control module is secured in
the 1-12 frame and pull the module out.
3.
Unpack the central control module.
CAUTION!
Static charge can damage electronic devices.
Observe the regulations regarding electrostati-
cally sensitive components.
4.
Carefully push the central control module into slot 0 (see also the illus-
tration
Forum Gateway 560: 1-12 frame slots
on page 94). The printing
on the front of the module should be at the top.
Ensure that the backplane plug of the central control module is securely
plugged into the socket on the backplane.
5.
Refit the screws to secure the module in the 1-12 frame.
6.
Plug the desired cables into the corresponding RJ45 sockets on the central
control module. Refer to
page 115 for information on pin assignment.
7.
Switch the Forum Gateway 560 on again. To do so, reconnect the group 1
power supply unit (see A in the illustration
on page 94) with the mains supply (if you are powering a
Forum Gateway 560 with two power supply units, reconnect the second
unit as well).
