Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 533 / 561

11
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
11.41
TESTING CURRENT FLOW (AMPERAGE)
Performing a current flow test requires the meter leads
be inserted into the correct cavities in the meter, and be
placed in series in the circuit to be tested. Refer to your
Digital Multi Meter’s owner’s manual for potential model
specific instructions. Ensure you are using acceptable
adapters to avoid damaging the connector terminals.
Connector Probing Guidelinespage 11.37
NOTICE
Amperage specs are generally not provided for circuits/
components. Please only perform this test when
advised in the manual.
CAUTION
Many circuits on this machine will exceed the 10 Amp
fuse in most Digital Multi Meters in normal operation.
TESTING PARASITIC DRAW
Parasitic draw is when there is excessive current flow
with the key off.
While the most common causes of draws are improperly
installed accessories (tapping into un-switched B +
instead of switched) there can be electronic component
failures that can cause this as well.
TESTING PROCEDURE
1. Remove the negative cable from the battery.
2. Connect a jumper from the negative battery cable
terminal to the negative battery post.
3. Ensure your meter leads and selector dial are set to
measure amperage.
4. Connect your red lead to the battery negative cable
terminal.
5. Connect your black lead to the battery negative post.
6. Momentarily key the ignition switch on, then off.
CAUTION
Ensure all electrical components are switched off, or
damage to your jumper and/or meter will occur.
7. Wait 30 minutes before checking the value. Vehicles
will vary, but electronic components will take time to
fully go to sleep after switched power is removed.
8. Maximum allowable is 10 milliamps. If your meter is
ranged to the 10 Amp scale, this will appear as 0.010
Amps.
9. If over 10 milliamps, go to the fuse block and start
systematically removing one fuse at a time until the
value drops, indicating the circuit that requires
attention.
ELECTRICAL