Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 325 / 561

6
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
6.13
TORQUE
Lower Intake Plenum Fastener:
22 lb-ft (30 Nm)
17. Wipe any dirt off the fuel line connector and the fuel
rail. Reconnect the fuel line to the fuel rail.
NOTICE
Be sure to gently tug on the fuel line after installing it to
make sure it is secured.
18. Connect the vehicle harness to the T-MAP sensor
(G), ETC (H), fuel injectors (J), rear differential relay
and rear differential solenoid (K).
19. Position the vehicle harness over the intake plenum
and install five new plastic tie straps to retain the
harness to the intake plenum.
20. Install the transmission shift cable and washer (L)
onto the bellcrank. Install the retaining clip (M).
21. Connect the CPS (N), vehicle speed sensor (P), ECT
sensor (Q) and transmission switch (R).
22. Install the vent line (S) to the transmission fitting.
23. Install two new plastic tie straps to retain the harness
to the transmission.
24. Note the location marks on the shift cable made
during transmission removal and install the shift cable
on the bracket (T). While holding the upper shift cable
jam nut (U), tighten the lower jam nut (V) to secure
the shift cable in the bracket.
TRANSMISSION