Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 384 / 561

7.36
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
REAR BEARING CARRIER BEARING
REPLACEMENT
1. Remove the retaining ring from the bearing carrier.
2. From the back side, tap on the outer bearing race
with a drift punch in the casting reliefs.
NOTICE
Drive bearing out evenly by tapping on outer race only.
Once bearing is at bottom of casting, support casting on
outer edges so bearing can be removed.
3. Inspect bearing carrier housing for scratches, wear
or damage. Replace rear bearing carrier if damaged.
4. Replace the bearing carrier bushings if worn or
damaged.
5. Thoroughly clean the rear bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite® 603 retaining compound to the outer
circumference of the new bearing race and carefully
press the new bearing into the bearing carrier
housing.
NOTICE
Use care to not allow any of the Loctite ® compound to
get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring (L).
REAR BEARING CARRIER INSTALLATION
1. Place the bearing carrier over the drive shaft.
2. Align the bottom of the bearing carrier with the lower
A-arm. Install the lower bearing carrier fastener.
FINAL DRIVE