Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 354 / 561

7.6
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
BEARING REPLACEMENT
Bearing Removal
1. Remove outer snap ring.
2. From back side of the bearing carrier, tap on the
outer bearing race with a drift punch in the reliefs as
shown.
3. Drive bearing out evenly by tapping on outer race
only. Once bearing is at bottom of casting, support
casting on outer edges so bearing can be removed.
4. Inspect bearing carrier housing for scratches, wear
or damage. Replace front bearing carrier if damaged.
Bearing Installation
5. Thoroughly clean the front bearing carrier housing
and the outer race on the new bearing. Be sure that
all oil residue has been removed from each surface.
6. Support the bottom of the bearing carrier housing.
CAUTION
Use an arbor and press only on the outer race,
otherwise bearing damage may occur.
7. Apply Loctite ® 603 retaining compound to the outer
circumference of the new bearing race (A) and
carefully press the new bearing into the bearing
carrier housing.
NOTICE
Use care to not allow any of the Loctite ® compound to
get in the bearing.
8. Wipe the housing clean of any excess compound
and install the snap ring.
BEARING CARRIER INSTALLATION
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
1. Install the end of the drive shaft through the backside
of the bearing carrier.
2. Install the upper and lower ball joint ends into the
front bearing carrier.
FINAL DRIVE