Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 324 / 561

6.12
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
7. Install the two bolts (E) and transmission joint retainer
plate (F) on the right side. Hand tighten the bolts so
they remain loose at this time.
8. Install the two longer bolts into left side mounting
holes. Torque left side mounting bolts to specification
using the numbered sequence shown.
9. Torque right side mounting bolts to specification using
the numbered sequence shown.
TORQUE
Engine / Transmission Mounting Bolts:
Step 1-2: 64 lb-ft (87 Nm)
Step 3: 5 lb-ft (7 Nm)
Step 4-7: 44 lb-ft (60 Nm)
10. Remove the clutch center distance tool.
11. Remove the spacer or support between the vehicle
frame and engine.
12. Torque the rear transmission mount bolt (B) to
specification.
TORQUE
Rear Transmission Mount Bolt:
40 lb-ft (54 Nm)
13. Remove the lifting straps and overhead or portable
hoist.
14. Install the intake plenum and throttle body assembly.
Place the intake plenum runners into the cylinder
head intake adapters.
NOTICE
Be sure the intake plenum runners are fully seated in
the intake adapters before tightening the hose clamps.
15. Tighten the hose clamps to specification.
TORQUE
Intake Plenum Hose Clamps:
17 lb-in (2 Nm)
16. Install the fastener securing the bottom of the intake
plenum to the rear transmission mount. Torque
fastener to specification.
TRANSMISSION