Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 54 / 561

2.16
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
3. Clean the area around the crankcase drain plug.
CAUTION
Use caution when performing this procedure. Do not
allow hot engine oil to come into contact with skin, as
serious burns may result.
4. Place a drain pan under the engine crankcase and
remove the drain plug. Allow the oil to drain
completely.
5. Remove all cargo from the cargo box.
CAUTION
Always remove all cargo from the cargo box before
lifting the box to access the engine.
6. Pull up on the cargo box release lever to tilt the box.
7. Gently press the clutch outlet duct
q
out of the way
to gain access to the oil filter
w
.
8. Using the Oil Filter Wrench ( PU-50105 ), turn the oil
filter
w
counter-clockwise to remove it.
Oil Filter Wrench:
PU-50105 : 2.5” (64 mm)
9. Using a clean dry cloth, clean the filter sealing
surface on the engine crankcase.
10. Lubricate the O-ring on the new oil filter with a film of
fresh engine oil. Check to make sure the O-ring is in
good condition. Install it to specification.
TORQUE
Oil Filter: Turn by hand until filter O-ring contacts
sealing surface, then turn an additional 3/4 turn.
11. Replace the sealing washer on drain plug.
NOTICE
The sealing surface on the drain plug should be clean
and free of burrs, nicks or scratches.
12. Reinstall the engine crankcase drain plug. Torque
drain plug to specification.
TORQUE
Crankcase Drain Plug:
12 lb-ft (16 Nm)
13. Remove oil fill cap (refer to Engine Oil Levelpage
2.15 procedure). Fill engine with recommended
engine oil.
FLUID CAPACITY
Recommended Engine Oil:
PS-4 Synthetic (PN 2876244)
Ambient Temp Range: -35° F to 100° F
PS-4 Extreme Duty Synthetic (PN 2878920)
Ambient Temp Range: 0° F to 120° F
Capacity: 2.5 Qt (2.4 L)
MAINTENANCE