Polaris RANGER XP 1000 2018-2019, Service Manual

Page: 513 / 561

11
9929399 R01 - 2018-2019 RANGER XP/ CREW 900/1000 Service Manual
© Copyright Polaris Industries Inc.
11.21
HEADLIGHT SERVICE
HEADLIGHT ADJUSTMENT
1. Place the vehicle on a level surface with the
headlight approximately 25 ft. (7.6 m) from a wall.
2. Measure the distance from the floor to the center of
the headlight (X
1 ) and make a mark on the wall at the
same height (X 2 ).
3. With the vehicle in Park, start the engine and turn the
headlight switch to the LOW position.
4. The most intense part of the LOW headlight beam
should be aimed 8 in. (20 cm) below the mark placed
on the wall in Step 2.
NOTICE
Rider weight must be included in the seat while
performing this procedure.
5. Remove the hood and locate the adjustment screw
q
on the side of the headlight housing. Adjust the
beam to the desired position by loosening the
adjustment screw and moving the lamp to the
appropriate height.
6. Once the beam is set to the position, tighten the
adjustment screw. Repeat the procedure to adjust
the other headlight.
WARNING
Due to the nature of light utility vehicles and where they
are operated, headlight lenses become dirty. Frequent
washing is necessary to maintain lighting quality. Riding
with poor lighting can result in severe injury or death.
HEADLIGHT BULB REPLACEMENT
1. Remove the hood from the front cab.
2. Locate the bulb on the back side of the headlight
housing.
3. Disconnect the harness from the bulb. Be sure to pull
on the connector, not on the wiring.
4. Turn the bulb counterclockwise and remove it from
the headlight housing.
5. Install the new bulb into the housing and rotate it
clockwise 90° to lock it in place.
NOTICE
Make sure the tab on the bulb locates properly in the
housing.
ELECTRICAL