Omron 3G3RX Series, User Manual

Page: 338 / 442

6-1
6-1 Inspection and Maintenance
6
Inspection and Maintenance
6Inspection and Maintenance
6-1 Inspection and Maintenance
„
Maintenance and Inspection
• Be sure to confirm safety before conducting maintenance, inspection or parts replacement.
„
Operation Stop Command
• Provide a separate emergency stop switch because the STOP key on the Digital Operator is valid only when
function settings are performed.
• When checking a signal during the power supply and the voltage is erroneously applied to the control input
terminals, the motor may start abruptly. Be sure to confirm safety before checking a signal.
„
Product Disposal
• Comply with the local ordinance and regulations when disposing of the product.
Do not change wiring and slide switches (SW1), put on or take off Digital Operator and optional
devices, replace cooling fans while the input power is being supplied. Doing so may result in a
serious injury due to an electric shock.
Do not remove the terminal block cover during the power supply and 10 minutes after the power
shutoff.
Doing so may result in a serious injury due to an electric shock.
Do not touch the Inverter fins, braking resistors and the motor, which become too hot during the
power supply and for some time after the power shutoff. Doing so may result in a burn.
Do not dismantle, repair or modify this product.
Doing so may result in an injury.
Safety Information
WARNING
CAUTION
Precautions for Use