Omron 3G3RX Series, User Manual

Page: 209 / 442

4-100
4-2 Function Mode
4
Functions
• You can select from three types of operators (AND, OR, and XOR).
• The setting parameters vary depending on the logic operation output selected.
Refer to the following table to set the necessary parameters.
(Example) To output a logic output 1 (LOG1) signal through AND operation of "RUN signal" (00:
RUN) and "over set frequency arrival signal" (02: FA2) to multi-function output 2
• Multi-function input 2 selection (C002)
: 33 (LOG1)
• Logic output signal 1 selection 1 (C142) : 00 (RUN)
• Logic output signal 1 selection 2 (C143) : 02 (FA2)
• Logic output signal 1 operator selection (C144): 00 (AND)
Capacitor Life Warning Signal
• This function determines estimated service life of the capacitor on the PCB, based on the Inverter's
internal temperature and ON time.
• Life assessment monitor d022 shows the status of this signal.
• If this function is activated, it is recommended that the main circuit board and logic board be
replaced.
Selected signal
Operand 1
selection
Operand 2
selection
Operator
selection
33: Logic operation output 1 (LOG1) C142 C143 C144
34: Logic operation output 2 (LOG2) C145 C146 C147
35: Logic operation output 3 (LOG3) C148 C149 C150
36: Logic operation output 4 (LOG4) C151 C152 C153
37: Logic operation output 5 (LOG5) C154 C155 C156
38: Logic operation output 6 (LOG6) C157 C158 C159
Output signal 1
Output signal 2
LOGx (AND)
LOGx (OR)
LOGx (XOR)
Parameter No. Function name Data Default setting Unit
C021 to C025
Multi-function output
terminal selection
39: WAC
(Capacitor life warning signal (on PCB))
⎯
⎯
C026
Relay output (MA, MB)
function selection
05