Mitsubishi Electric MELSEC Q Series, User Manual

Page: 785 / 834

16 - 39
Chapter 16 Troubleshooting
Related buffer memory address
Set range
(Setting with sequence program)
Remedy
64+150n
65+150n
0 to 327680
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
63+150n 0, 1
67 0, 1
68+150n
<Torque initial value selection (b4 to b7)>
0, 1
<Speed initial value selection (b8 to b11)>
0, 1, 2
<Condition selection at mode switching
(b12 to b15)>
0, 1
69+150n 0, 1, 2, 3, 4
— —
With remove causes, switch the power on again or reset the
PLC.
70+150n
[RJ010 mode] 0, 4, 5, 6, 7
[CiA402 mode] 8
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON. 71+150n 0, 1
72+150n
73+150n
• [mm] [inch] [PLS]
–2147483648 to 2147483647
• [degree] 0 to 35999999
74+150n
75+150n
<HPR speed>
1 to 1000000000 [PLS/s]
1 to 2000000000 [ 10
-2
mm/min or others]
• Bring the setting into the setting range.
• Set the speed to the bias speed at start or higher.
(Refer to Section 5.2.5)
n: Axis No.-1