Mitsubishi Electric MELSEC Q Series, User Manual

Page: 66 / 834

2 - 6
Chapter 2 System Configuration
(b) Mounting to a MELSECNET/H remote I/O station
The QD77GF cannot be mounted to any MELSECNET/H remote I/O stations.
Mount the module on a base unit on which a CPU module is mounted.
(2) Compatibility with multiple CPU system
When using the Simple Motion module in a multiple CPU system, refer to the
QCPU User's Manual (multiple CPU system). The Simple Motion module
supports the multiple CPU system.
(a) Network parameters
Network parameters are set to the control CPU of the Simple Motion module.
(b) Diagnosing from another station using GX Works2
When there is the CPU module that does not support the Simple Motion
module in another CPU other than the control CPU, it cannot diagnose from
another station using GX Works2. (e.g. PC diagnostics, system monitor)
To diagnose the CPU, connect GX Works2 to the control CPU when
diagnosing cannot be executed from another station.
(3) Programming tool
The applicable programming tool's versions of the Simple Motion module are
shown below.
(For the applicable programming tool's versions of the CPU module, refer to the
"QCPU User's Manual (Hardware Design, Maintenance and Inspection)".)
Version
GX Works2 MR Configurator2
QD77GF4
Version 1.540N or later Version 1.49B or later QD77GF8
QD77GF16 [CiA402 mode]
QD77GF16 [RJ010 mode]
Version 1.98C or later Version 1.19V or later
REMARK
QD77GF cannot be supported with GX Developer, GX Configurator-QP and
MR Configurator.
Use GX Works2 and MR Configurator2 to use QD77GF.