DISASSEMBLY
1) Remove B terminal inner nut (1) and insulator (2).
2) Remove 3 screws (3) and remove rear end cover (4).
3) Remove 2 screws (1) and pull out brush holder assembly (2).
4) Remove 3 screws (3) and IC regulator (4).
5) Remove brush holder cover from brush holder.
6) Remove rectifier holder screws (1).
7) Remove rectifier holder (2).
8) Hold shaft by using hexagonal box wrench and remove pulley
nut (1), and then pull out pulley (2).
CAUTION:
To hold shaft, use hexagonal box. Duodecimal box
may cause slipping and consequential shaft or
tool damage.
Do not attempt to hold pulley by using vise or pipe
wrench so as not to distort it.
9) Remove rear end frame nuts (3) and bolts (4).
10) Drive out rear end frame (1) with rotor tapping shaft (2) lightly
by using plastic hammer.
11) Separate rear end frame from rotor evenly by using plastic
hammer.
CAUTION:
Do not hit shaft at slip ring side, when separating ro-
tor and rear end frame.
CHARGING SYSTEM
6H-15
