4) Apply water tight sealant to joint seam of axle and mating sur-
faces of brake back plate.
“C” : Sealant 366E, 99000-31090
5) Install brake back plate to rear axle and tighten back plate bolts
to specified torque.
Tightening Torque
(b) : 23 N·m (2.3 kg-m, 16.5 lb-ft)
6) Put brake hose/pipe through hole in bracket on axle and se-
cure it with E-ring (3) and remove breeder plug cap (1) from
end of pipe. Then tighten pipe flare nut (4) to wheel cylinder (2)
to specified torque.
Tightening Torque
(c): 16 N·m (1.6 kg-m, 11.5 lb-ft)
7) Apply water tight sealant where plate and cable contact, and
run parking brake cable through back plate and secure it with
clip, refer to BRAKE BACK PLATE in Section 5.
8) Install brake shoe, refer to BRAKE SHOE in Section 5.
9) Install brake drum. (Refer to WHEEL BEARING AND WHEEL
STUD in this section.)
10) Fill reservoir with brake fluid and bleed brake system. (For
bleeding operation, refer to BLEEDING BRAKES in Section
5.)
11) Upon completion of all jobs, depress brake pedal with about
30kg (66 lbs) load two to three times so as to obtain proper
drum-to-shoe clearance.
12) Check to make sure that brake drum is free from dragging and
brake works properly. Then lower vehicle from lift and perform
brake test.
3E-10
REAR SUSPENSION
