7) Replenish oil until oil level is brought to FULL level mark on dip-
stick (oil pan and oil filter capacity). Filler inlet is at the top of cyl-
inder head cover.
8) Start engine and run it for three minutes. Stop it and wait another
5 minutes before checking oil level. Add oil, as necessary, to
bring oil level to FULL level mark on dipstick.
1. Low level mark (hole)
2. Full level mark (hole)
NOTE:
Engine oil capacity is specified as left table.
However, note that amount of oil required when actually
changing oil may somewhat differ from data in left table de-
pending on various conditions (temperature, viscosity,
etc.).
9) Check oil filter and drain plug for oil leakage.
Engine oil capacity
Engine Coolant Change
Refer to Section 6B of this manual for coolant capacity.
WARNING:
To help avoid danger of being burned, do not remove ra-
diator cap while engine and radiator are still hot. Scald-
ing fluid and steam can be blown out under pressure if
cap is taken off too soon.
CAUTION:
When changing engine coolant, use mixture of 50% wa-
ter and 50% ethylene-glycol base coolant (Anti-Freeze/
Anti-corrosion coolant) for the market where ambient
temperature falls lower than –16 C (3 F) in winter and mix-
ture of 70% water and 30% ethylene-glycol base coolant
for the market where ambient temperature doesn’t fall
lower than –16 C (3 F).
Even in a market where no freezing temperature is antici-
pated, mixture of 70% water and 30% ethylene-glycol
base coolant should be used for the purpose of corro-
sion protection and lubrication.
0B-8
MAINTENANCE AND LUBRICATION
Oil pan capacity
about 2.5 liters
(5.3/4.4 US/lmp pt.)
Oil filter capacity
about 0.2 liter
(0.4/0.3 US/lmp pt.)
Others
about 0.3 liter
(0.6/0.5 US/lmp pt.)
Total
about 3.0 liters
(6.3/5.3 US/lmp pt.)
