INSPECTION
NOTE:
Do not disassemble water pump.
If any repair is required on pump, replace it as assembly.
Rotate water pump by hand to check for smooth operation.
If pump does not rotate smoothly or makes abnormal noise, re-
place it.
INSTALLATION
F8B engine
1) Install new gasket to cylinder block.
2) Install water pump to cylinder block.
Tightening Torque
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
3) Install timing belt inside cover.
4) Install crankshaft timing belt guide, pulley and camshaft timing
belt pulley.
Tightening Torque
(a): 55 N·m (5.5 kg-m, 40.0 lb-ft)
5) Remove cylinder head cover and loosen all valve adjusting
screws of intake and exhaust rocker arms fully.
6) Install belt tensioner, tensioner spring and timing belt and ad-
just timing belt tension according to procedure described in
TIMING BELT AND TENSIONER of SECTION 6A.
7) Install timing belt outside cover, crankshaft pulley, water pump
pulley and drive belts Refer to SECTION 6A.
8) Adjust all valve lashes refer to SECTION 6A.
9) Adjust water pump drive belt tension and A/C compressor
drive belt tension (if equipped).
10) Connect negative cable at battery.
11) Fill cooling system.
ENGINE COOLING
6B-13
