6) Using special tool (Valve lifter), compress valve spring and fit
two valve cotters (1) to groove provided in valve stem.
Special Tool
(A): 09916-14510
(B): 09916-48210
(C): 09916-84511
2. Valve spring retainer
7) Be sure that locating pins (3) are in place and then install new
head gasket, in such a way that “TOP” mark (1) provided on the
gasket comes crankshaft pulley side, facing up (toward cylinder
head side), “IN” mark (2) comes on intake manifold side and
“EX” mark comes on exhaust side.
8) Install cylinder head onto cylinder block.
9) Apply engine oil to cylinder head bolts and tighten them gradual-
ly as follows.
a) Tighten all bolts to 34 N·m (3.4 kg-m, 24.5 Ib-ft) according to
numerical order in figure.
b) In the same manner as a), tighten them to 54 N·m (5.4 kg-m,
39.0 Ib-ft).
c) Loosen all bolts to 0 N·m (0 kg-m, 0 Ib-ft), reversing to numer-
ical order in figure.
d) In the same manner as a) again, tighten them to 54 N·m (5.4
kg-m, 39.0 Ib-ft).
e) In the same manner as a) again, tighten them to specified
torque.
Tightening Torque
(a): 68 N·m (6.8 kg-m, 49.5 Ib-ft)
ENGINE MECHANICAL (F8B ENGINE)
6A-41
