10) Disconnect the following electric wires.
Radiator fan
Distributor (High-tension cord and terminal)
Starter motor
Generator
Back-up light switch
Oil pressure switch
Oxygen sensor
ECT sensor
Right side of engine harness
Ground wire from cylinder block
Ground wire from transmission case
A/C compressor (if equipped)
11) Remove exhaust center pipe.
12) Disconnect gear shift control shaft (1) and extension rod (2)
from transmission case.
13) Drain engine and transmission oil.
14) Remove stabilizer bar, refer to Section 3D.
15) Disconnect right and left drive shaft joints from differential side
gear snap rings.
6A-6
ENGINE MECHANICAL (F8B ENGINE)