3) Install crankshaft to cylinder block.
4) Install bearing cap to cylinder block, making sure to point arrow
mark (on each cap) to crankshaft pulley side. Fit them sequen-
tially in ascending order, 1, 2, 3 and 4, starting from pulley side.
Tighten bearing cap bolts in such order as shown in figure a little
at a time and repeat it till they are tightened to specified torque.
Tightening Torque
(a): 47 N
.
m (4.7 kg-m, 34.0 lb-ft)
NOTE:
After tightening cap bolts, check to be sure that crankshaft
rotates smoothly when turning it by 7.0 N
.
m (0.7 kg-m, 5.0
lb-ft) torque or below.
5) Install new gasket and oil seal housing.
Do not reuse gasket removed in disassembly. Apply engine oil
to oil seal lip before installation. Tighten housing bolts to specifi-
cation.
Tightening Torque
(a): 11 N
.
m (1.1 kg-m, 8.0 lb-ft)
NOTE:
As there are 2 types (long bolts (1) and short bolts (2)) of
housing bolts, refer to figure for their correct use.
After installing oil seal housing, gasket edges might bulge out;
if so, cut them off to make them flush with cylinder block and oil
seal housing.
6) Install oil pump.
Refer to item OIL PUMP for installation of oil pump.
7) Install flywheel.
Using special tool, lock flywheel, and torque its bolts (1) to spec-
ification.
Special Tool
(A): 09924-17810
Tightening Torque
(a): 42 N
.
m (4.2 kg-m, 30.5 lb-ft)
6A1-62
ENGINE MECHANICAL (F8D ENGINE)
