Insert interlock steel balls through shaft hole. Through this hole, in-
sert one ball between each of 2 adjacent shafts. Use interlock steel
balls with an outside diameter of 9.5 mm
(0.374 in.
).
NOTICE:
Be sure to put in pin for preventing two shafts from getting
shifted at the same time. This pin (1) goes into the hole pro-
vided in high-speed shaft.
Gear shifter fork and shaft stopper pins
Drive the shifter fork pins (low-speed, high-speed and reverse) into
the shifter fork and shaft completely.
Drive the shifter shaft stopper pins into the shifter shaft so that di-
mension H is obtained, as illustrated in below figure.
A : Shifter fork pin
Length 20 mm 10.79 in.)
. . . .
A-1
: Shifter fork pin
Length 18 mm 10.71 in.)
. . . .
B : Stopper pin
Length 18 mm 10.71 in.)
. . . . . .
H : Low-speed stopper pin height
3 mm (0.12 in.)
H : High-speed stopper pin height 0 mm (0 in.)
H : Reverse stopper pin height
3 mm (0.12 in)
MANUAL TRANSMISSION (4-SPEED)
7A-21
