Timing belt inside cover
When reinstalling the inside cover (1) to cylinder head, apply seal-
ant to the threads of upper side screws (2) as shown, because the
bolt holes for the two extend into the interior of cylinder head.
“A” Sealant 99000-31110
Crankshaft timing belt guide
This guide takes its position on crankshaft as shown in figure. Re-
member, one side of this guide (3) faces the cylinder block and the
other side faces the timing belt pulley (2): the former side being dis-
tinct from the latter.
1. Crankshaft pulley
Camshaft and crankshaft timing belt pulleys
These pulleys have a punch-mark (1) to show that the marked side
faces the timing belt outside cover. When installing each pulley, di-
rect this mark to timing belt outside cover side.
Tighten camshaft pulley bolt to specified torque.
Tightening Torque for camshaft pulley bolt:
55 N·m (5.5 kg-m, 40.0 Ib-ft)
2 Keyway
Timing belt
A certain sequence must be followed installing the timing belt.
Here’s the sequence:
1) Put the tensioner and the spring together before installing them
as one to the timing belt cover. Tighten the bolts to the extent that
the tensioner can be moved by hand easily.
NOTE:
When carrying out the above job, make sure to loosen each
lock nut and then each valve clearance adjusting screw so
that the camshaft and the pulley can rotate freely.
ENGINE MECHANICAL (F8B ENGINE)
6A-43
