Rev.A 12-12
Wheel Lock
Model. FNU200
by
User
Manual
PLEASE READ THIS
MANUAL BEFORE
FIRST USE.
TIME INVESTED IN
CORRECT FITMENT
IS REPAID IN THE
LEVEL OF SECURITY
THAT IS ACHIEVED.
design...innovate...improve
Nemesis
Page 1: ... A 12 12 Wheel Lock Model FNU200 by User Manual PLEASE READ THIS MANUAL BEFORE FIRST USE TIME INVESTED IN CORRECT FITMENT IS REPAID IN THE LEVEL OF SECURITY THAT IS ACHIEVED design innovate improve Nemesis ...
Page 2: ...ation Fitting Diagrams 1 Shield Plate 2 Wheel Bar 3 Lock Unit 4 Receiver Wheel Bolt 5 1mm Spacer Ring x20 6 Lock Unit Hex Screw 7 3mm Hex Key 8 Key x2 9 19mm Wheel Wrench Adapter 2 3 1 4 5 6 7 9 Fig C Fig B Fig D Fig A ...
Page 3: ...mbinations of how the Nemesis Ultra may fit to a particular wheel Fig C shows that the Wheel Bar 2 is designed to slide in or out as necessary depending on where the Receiver Bolt 4 has been installed in relation to which gap in the wheel s spokes the Wheel Bar 2 fits through Note When installing the device the Wheel Bar 2 should be located through the lower part of the wheel so that it does not h...
Page 4: ...d on both of the keys supplied and will be required in order to purchase replacement keys Registration is quick and simple go to www purpleline co uk product registration Try to gauge the amount of gap and add the necessary amount of 1mm thickness Spacer Rings 5 between the Shield Plate 1 and the Lock Unit 3 as shown in Fig A If you add too many Spacer Rings 5 it will not be possible to fully enga...
