Keithley SourceMeter 2400, User Manual

Page: 425 / 594

18-44 SCPI Command Reference 2400 Series SourceMeter
®
User’s Manual
Clear test results
[:IMMediate]
:CALCulate2:CLIMits:CLEar[:IMMediate] Clears test results and resets Digital I/O
Port
Description This command clears the test results (pass or fail) of the limit tests and
resets the output lines of the Digital I/O port back to the :SOURce2:TTL
settings. (See
“SOURce2,” page 18-100 , subsystem.)
AUTO <b>
:CALCulate2:CLIMits:CLEar:AUTO <b> Control auto-clear for test results
Parameters <b> = 1 or ON Enable auto-clear
0 or OFF Disable auto-clear
Query
:AUTO? Query state of auto-clear
Description
With auto-clear enabled, test results will clear and the output lines of the
Digital I/O port will reset when the :INITiate command is sent to start a
new test sequence.
When disabled, you must use :IMMediate to perform the clear actions.
CALCulate3
Select statistic
FORMat <name>
:CALCulate3:FORMat <name> Specify CALC3 format
Parameters
<name> = MEAN Mean value of readings in buffer
SDEViation Standard deviation of readings in buffer
MAXimum Largest reading in buffer
MINimum Lowest reading in buffer
PKPK MAXimum - MINimum
Query
:FORMat? Query programmed math format
Description
This command is used to select the desired statistic on readings stored in
the buffer. See
Section 9 , “ Data Store ,” for details on these statistics.
Readings stored in the buffer can be “raw” measured readings, the
results of the CALC1 calculation, or CALC2 readings. The
:TRACe:FEED command in the :TRACe Subsystem is used to select the
type of readings to store.
Provides statistical data on buffer readings
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com