IBM Netfinity 3000, User Handbook Manual

Page: 231 / 370

Ethernet controller messages
Table 11 (Page 1 of 3). Ethernet controller messages
Error Code Description
RPL-ROM-ERR: 100 The integrated Ethernet controller
cannot be found.
Action: Make sure that the Ethernet
controller is enabled in the BIOS. If the
problem persists, have the system
serviced.
RPL-ROM-ERR: 101 The integrated Ethernet controller was
unable to initialize.
Action: Make sure that the Ethernet
controller is enabled in the BIOS. If the
problem persists, have the system
serviced.
RPL-ROM-ERR: 102 The integrated Ethernet controller could
not be reset.
Action: Make sure that the Ethernet
controller is enabled in the BIOS. If the
problem persists, have the system
serviced.
RPL-ROM-ERR: 103 There are multiple Ethernet controllers
or adapters in the system.
Action: Specify the correct serial
number in the NET.CFG file.
RPL-ROM-ERR: 104 The integrated Ethernet controller
EEPROM is faulty or not present.
RPL-ROM-ERR: 105 The integrated Ethernet failed the
loopback test.
A power-on diagnostic test performed
by the Ethernet module did not execute
correctly.
Action: Have the system serviced.
RPL-ROM-ERR: 106 The integrated Ethernet controller is
configured for Plug and Play in a
non-Plug and Play system.
RPL-ROM-ERR: 107 The media test failed.
Action: The cable from the LAN is not
securely connected to the Ethernet port
on your server. Check the cable to
ensure that it is properly connected.
Chapter 5. Solving problems
197