IBM Netfinity 3000, User Handbook Manual

Page: 206 / 370

POST Messages
POST message Description
163 The clock is not working correctly.
Action: Set the correct date and time. If the date and time are
set correctly and saved, but the 163 error message reappears,
replace the battery. (See “Replacing the battery” on page 224.)
If this does not correct the problem, have the system serviced.
Until the system is serviced, the server can be used, but any
application programs that use the date and time will be affected.
164 A change in the memory configuration occurred. This message
might appear after you add or remove memory, or incorrectly
install memory.
Note: The server can be used with decreased memory capacity
until the error is corrected.
Action:
1. If you added memory, see “Working with memory modules”
on page 96 to verify that the new memory is correct for your
server and that it is installed correctly. (If the memory is not
installed correctly, reseat the memory modules.)
2. If you added or removed memory, you must save the new
configuration in the Configuration/Setup Utility program.
Run the Configuration/Setup Utility program; then, exit,
saving the new configuration settings. For information about
using the Configuration/Setup Utility program, see “Using
the Configuration/Setup Utility program” on page 39.
3. Running the diagnostic tests might isolate the location of the
problem memory module and provide additional
information. (See “Running the diagnostic test programs” on
page 164 for information on running the diagnostic programs
that come with your server.)
If the problem cannot be isolated and corrected, have the
system serviced.
172
Netfinity 3000 User's Handbook