IBM Netfinity 3000, User Handbook Manual

Page: 85 / 370

Using the Configuration/Setup Utility program
password is entered. This feature will work if your server is
powered on or off.
To enable or disable enhanced security:
Note: Enhanced security can be enabled or disabled only when you
update the system programs in your server.
1. Insert a Flash BIOS diskette in your server. System programs
updates are available on the World Wide Web. To obtain
up-to-date information about your server model, access the
home page for your server at the following address:
http://www.ibm.com/netfinity/
2. Turn on the server. If it is already turned on, you must turn it
off and back on again.
3. The update begins, and the system prompts you for the
administrator password, if you have set an administrator
password.
4. When you enter the administrator password, the Flash BIOS
diskette will continue to run, and you are given the option of
enabling or disabling enhanced security.
To set, change, or delete an administrator password protected by
enhanced security:
1. Turn off all attached devices and the server.
2. See Chapter 4, “Installing options” on page 67 for safety
information, disconnecting all cables, and removing the server
cover.
3. Locate the switch marked as 7 on the rocker switches section of
the system board. See “Setting the administrator password
switch” on page 266 for the location of the switch. Move the
switch to the ON position. (It might be helpful to use the end
of a small screwdriver to set the switch.)
Note: You must know the administrator password to change or
delete it.
Chapter 3. Configuring your server
51