IBM Netfinity 3000, User Handbook Manual

Page: 208 / 370

POST Messages
POST message Description
177 A security (inventory) violation has occurred.
The Asset Control System Security feature has detected that the
values for AssetCare and Asset ID have been set to Enabled, and
the server has been moved without authorization.
Action: You must enter the administrator password to clear this
POST message.
From the Configuration/Setup Utility menu, select System
Security.
Then, follow the instructions on the screen. Set the
values for AssetCare and Asset ID to Disabled. For information
on using the Configuration/Setup Utility program, see “Using
the Configuration/Setup Utility program” on page 39.
If the problem persists, have the system serviced.
183 The privileged-access protection message is received if the
administrative password has been enabled.
Action: You must enter the administrator password to clear this
POST message. If the message recurs when the cover has not
been removed, have the system serviced.
184 Invalid power-on password checksum received.
The values for AssetCare and Asset ID have been set to Enabled,
and an RFID Antenna has been installed.
Action:
From the Configuration/Setup Utility menu, select System
Security.
Then, follow the instructions on the screen. Set the
values for AssetCare and Asset ID to Disabled. An RFID
Antenna should not be installed. For information on using the
Configuration/Setup Utility program, see “Using the
Configuration/Setup Utility program” on page 39.
If this information cannot be restored, have the system serviced.
186 A system board or hardware security error has been cleared.
Action: The administrator password was entered to clear POST
message 176. No further action is required.
187 The administrator password and startup (boot) sequences have
been cleared. POST message 162 will normally display also.
Action: See POST message 162
190 The server tamper indicator was cleared.
Action: No action is required.
174
Netfinity 3000 User's Handbook