IBM Netfinity 3000, User Handbook Manual, Page: 142 / 370

Installing or removing internal drives
Front Fan Connector
Disk Fan A
Connector
Disk Fan B
Connector
Modem Wakeup Connector
PCI
PCI
PCI
ISA
ISA
ISA
340-Pin
Connector
SCSI Hard Disk LED
Connector
Wake on LAN Connector
Asset ID Antenna
Connector
Alert on LAN
Connector
Chassis-Intrusion
Detector Connector
Internal Speaker
Connector
CD
Audio
Connector
The following are some important points to remember when
connecting power and signal cables to internal drives:
Ÿ
The diskette drive, hard disk drive (if applicable), and CD-ROM
drive that are preinstalled in your server come with power and
signal cables attached. The CD-ROM drive is attached to the
secondary IDE connector on the back of the riser card. If you
replace any drives, it is important to remember which cable is
attached to which drive.
Ÿ
When you install a drive, ensure that the connector at the end of
the signal cable is connected to the system board.
Ÿ
The CD-ROM drive and the diskette drive are IDE devices that
come with your server. You can install another IDE device,
such as a CD-ROM drive or tape drive.
Ÿ
If two or more IDE devices are used on a single cable, one must
be designated as the primary or master device and all others as
secondary or subordinate devices; otherwise, some of the IDE
devices might not be recognized by the system. The primary or
108
Netfinity 3000 User's Handbook