IBM Netfinity 3000, User Handbook Manual

Page: 201 / 370

POST Messages
Attention:
If you did not change any settings in the
Configuration/Setup Utility program, note the following:
Ÿ
You will get an error message if you exit from the
Configuration/Setup Utility program without selecting
Save Settings
. Your operating system will not start, but
the server will automatically restart. When the server
restarts, you will get a POST error message, and then
the Configuration/Setup Utility program will again start
automatically.
Ÿ
You will not get an error message if you select Save
Settings
and then exit from the Configuration/Setup
Utility program. Your system will save all settings as
they currently appear in the Configuration/Setup Utility
program, and your operating system will start (unless
there is an unresolved problem with the startup device).
e. To exit from the Configuration/Setup Utility program, press
Esc and follow the instructions on the screen.
Chapter 5. Solving problems
167