IBM Netfinity 3000, User Handbook Manual

Page: 165 / 370

Working with microprocessors
5. Press the microprocessor into the connector until it snaps into
place and is fully seated in the connector.
6. If the microprocessor has tabs at the upper corners instead of an
adapter with a handle, pull outward on the retainer tabs to
secure the microprocessor in place.
7. If you replace the microprocessor with one that has a different
speed, you must change the switch settings on the system
board. To locate the switches, see “System Board Illustration”
on page 253. For information about the appropriate switch
settings, see “Setting the microprocessor speed switches” on
page 258, or see the label inside the server side cover.
8. Go to Table 14 on page 246 to update the microprocessor
information; then, return here.
9. If you receive the error code 167 after you install a new
microprocessor, run the Flash Utility program. Insert the Flash
Chapter 4. Installing options
131