IBM Netfinity 3000, User Handbook Manual, Page: 207 / 370

POST Messages
POST message Description
167 An installed microprocessor is not supported by the current
POST/BIOS.
Action:
1. Obtain the latest POST/BIOS update diskette image.
2. Perform the POST/BIOS (flash) update procedure (see
“Remote Administration” on page 52 for additional
information).
3. Verify the microprocessor switch settings (see “Setting the
microprocessor speed switches” on page 258).
Note: Although you might have the current POST/BIOS level,
you must still perform the POST/BIOS (flash) update
procedure to clear this error.
168 The Alert on LAN feature is not working correctly.
Action: Set the correct state in the Configuration/Setup Utility
program, as follows:
1. From the Configuration/Setup Utility menu, select I/O
Devices and Ports. Then, follow the instructions on the
screen.
2. Select Ethernet Setup.
3. Select Alert on LAN.
4. Set the value for Alert on LAN to Enabled.
For information on using the Configuration/Setup Utility
program, see “Using the Configuration/Setup Utility program”
on page 39.
Verify that the Ethernet cable is attached to both the client and
server, and that the appropriate software is installed on both the
client and server.
If the problem cannot be isolated and corrected, have the system
serviced.
175 A failure occurred during testing of the system board and
microprocessor.
Action: Have the system serviced.
176 The server cover has been removed.
Action: You must enter the administrator password to clear this
POST message. If the message recurs when the cover has not
been removed, have the system serviced.
Chapter 5. Solving problems
173