IBM Netfinity 3000, User Handbook Manual

Page: 98 / 370

Using the SCSISelect Utility program
To reset the SCSI controller defaults, press F6; then, follow the
instructions on the screen.
SCSI Disk Utilities
To see the IDs that are assigned to each SCSI device or to format a
SCSI device, select SCSI Disk Utilities from the SCSISelect Utility
program menu.
To use the utility program, select a drive from the list. Read the
screens carefully before you make a selection.
Note: If the following screen appears, you might have pressed
Ctrl
+
A before the selected drives were ready. Restart the
server, and watch the SCSISelect messages as each drive spins
up. After the drive that you want to view or format spins
up, press Ctrl
+
A .
à ð
Unexpected SCSI Command Failure
Target SCSI ID: 4
SCSI CDB Sent: ð3 ðð ðð ðð ðE ðð ð7 ðð ð2 ðð
Host Adapter Status: ððh - No host adapter error
Target Status: ð2h - Check condition
Sense Key: ð2h - Not ready
+Sense Code: ð4h
+Sense Code Qualifier: ð2h
Press 'Esc' to continue.
á ñ
Performing a low-level disk format
You can use the Format Disk feature of the SCSISelect Utility
program to perform a low-level format on hard disks.
64
Netfinity 3000 User's Handbook