HP 3562A, Service Manual

Page: 51 / 570

I
ODEL 3562A
PERFORMANCE TESTS
PART B
PERFORMANCE TESTS
2-1 7 INTRODUCTION
To verify the the HP 3562A is meeting its publ ished specifications, the performance tests
must be done in the order l isted every twelve months. Use the "Operational Verification,"
part A, for incoming and after-repair inspections. The performance tests take approximately
eight hou rs to complete.
2-1 8 HOW TO USE PART B
1 . Start each performance test by setting the test equipment to the preset cond itions
listed in the "Initial Equ ipment Setup," paragraph 2-20.
2. There are two types of keys on the H P 3562A, hard keys and soft keys. I n this section
the hard keys are in bold text, and the soft keys are in regu lar test.
For example:
F REQ
FREQ SPAN
1 0
kHz
This example instructs you to press the hard key FREQ and the soft key FREQ SPAN.
After pressing the soft key FREQ SPAN enter 10 kHz.
3. Refer to figu re 2-1 0 for the position of the X and Y marker readings.
4. Record the results of each of the performance tests on the "Performance Test Record,"
paragraph 2-42. This test record may be reproduced without written permission of
Hewlett-Packard.
5. If the H P 3562A fails a test, use the "If Test Fails Check:" paragraph at the end of
each test.
X � 2 5 . 0 k D X � 5 0 . O k Y � - 3 5 l . 4 B 6 D Y � 1 2 . 0 2 4 2
Y a = - 3 S 1 . S d B 6. Y a = 1 2 . 0 3 4
S Y N T H E S I S
- 3 4 4
/ O i v
B . 0
d B
- 4 0 B
Figure 2-1 0 Marker Positions
P
1 Z
o e e r a
H z
l O O k
2-29