General Music S2 Turbo, Owner'S Manual

Page: 153 / 304

137
Master Transpose Enables/disables the Master Transpose function. Tracks disabled for Transpose are
automatically tuned to play the “Equal Intonation Scale” ( s.). Disable Master Transpose for
the drumkit track to prevent the drum configuration from being altered.
Value range: Enable/Disable (---).
Page 3: Local
(S2/S3)
Parameter for the “local” controls (keyboard and controllers) and for the M
IDI
-C
OMMON
.
Aftertouch Activates/deactivates the Aftertouch for the track. Aftertouch is the pressure applied to the
note while you hold it down. Aftertouch can affect both the track and the corresponding M
IDI
channel (Channel or Mono) or affect only the note which is pressed (Poly).
Note: When “Aftertouch” is disabled, Aftertouch messages received at M
IDI
I
N
(non M
IDI
-
C
OMMON
channels) will continue to affect the notes played.
Value range: Off (---), Channel/Poly.
Wheel 1 Activates/deactivates Wheel 1 (left) for the track.
Value range: On/Off (---).
Wheel 2 Activates/deactivates Wheel 2 (right) for the track.
Value range: On/Off (---).
Pedal 1 Activates/deactivates Pedal/Footswitch 1 for the track.
Value range: On/Off (---).
Pedal 2 Activates/deactivates Pedal/Footswitch 2 for the track.
Value range: On/Off (---).
Valid only in multi mode (local & common)
The following two parameters affect the tracks of a Performance only when it is set to
MULTI
MODE
and only for the
LOCAL
/
MIDI
-
COMMON
Source.
Key range The keyboard extension across which the track can play. This is a useful setting to create
Performances with different sounds assigned to different sections of the keyboard (e.g.
Acoustic Bass at the lower end, GrandPiano at the centre and Flute at the higher).
1. Select the parameter. A keyboard with a horizontal bar will appear on the display showing
the current track extension:
2. Select the lowest note by pressing a note on the keyboard or by rotating the
DIAL
.
3. Press
ENTER
to pass to the next note limit. Select the highest note by pressing the note on
the keyboard or rotating the
DIAL
.
4. Press
ENTER
to confirm the Key Range or
EXIT
to escape.
Dynamic range Dynamic range of the track. Above and below these limits the track will not play. If the limits
fall between 0 and 127 the track will always play.
Value range: 0 ... 127 - 0 ... 127.
Hint: By programming two tracks with adjacent Dynamic ranges (e.g. 0-112 and 113-127)
you can create
cross-switch combinations without using the Sound Patches (s.).
(4) Edit Performance/Tracks