General Music S2 Turbo, Owner'S Manual

Page: 154 / 304

138 REFERENCE GUIDE
Page 3: Local (S2R)
Parameters valid for L
OCAL
/M
IDI
-C
OMMON
.
Page 3: Local (S2R)
Aftertouch Activates/deactivates the Aftertouch for the track. Aftertouch is the pressure applied to the
note while you hold it down. Aftertouch can affect both the track and the corresponding
M
IDI
channel ( Channel or Mono Touch) or affect only the note which is pressed (Poly
Touch).
Note: “Aftertouch” affects messages originating from M
IDI
-C
OMMON
. Even when Off,
Aftertouch messages originating from the other M
IDI
I
N
channels (not M
IDI
-C
OMMON
) will affect
the notes played.
Value range: Off (---), Channel/Poly.
Footswitch 1 & 2 Activates/deactivates Footswitches 1 and 2 for the track.
Value range: On/Off (---).
Valid only in multi mode (local & common)
The following two parameters affect the tracks of a Performance only when it is set to multi
mode and only for the
LOCAL
/
MIDI
-
COMMON
Source.
Key range The keyboard extension across which the track can play. This is a useful setting to create
Performances with different sounds assigned to different sections of the keyboard (e.g.
Acoustic Bass in the bass section, GrandPiano at the centre and Flute in the higher sec-
tion).
1. Select the parameter. A keyboard with a horizontal bar will appear on the display showing
the current track extension:
2. Select the lowest note by pressing a note on the keyboard or by rotating the
DIAL
.
3. Press
ENTER
to pass to the next note limit. Select the highest note by pressing the note on
the keyboard (only if connected via Midi-Common) or by rotating the
DIAL
.
4. Press
ENTER
to confirm the Key Range or
EXIT
to escape.
Dynamic range Dynamic range of the track. Above and below these limits the track will not play. Between 0
and 127 the track will always play.
Value range: 0 ... 127 - 0 ... 127.
Hint: By programming two tracks with adjacent Dynamic Ranges (e.g. 0-112 and 113-127)
you can create
cross-switch combinations without using the Sound Patches (s.).