Fuji Electric FRENIC-Ace series, User Manual

Page: 742 / 788

Appendix A Trouble-free Use of Inverters (Notes on electrical noise)
Appendix-2
A.2 Noise
This section gives a summary of noises generated in inverters and their effects on devices subject to noise.
[ 1 ] Inverter noise
Figure A-1 shows an outline of the inverter configuration. The inverter converts AC to DC (rectification) in a
converter unit, and converts DC to AC (inversion) with 3-phase variable voltage and variable frequency. The
conversion (inversion) is performed by PWM implemented by switching six transistors (IGBT: Insulated Gate
Bipolar Transistor, etc), and is used for variable speed motor control.
Switching noise is generated by high-speed on/off switching of the six transistors. Noise current (i) is emitted and
at each high-speed on/off switching, the noise current flows through stray capacitance (C) of the inverter, cable and
motor to the ground. The amount of the noise current is expressed as follows:
i = C · dv/dt
It is related to the stray capacitance (C) and dv/dt (switching speed of the transistors). Further, this noise current is
related to the carrier frequency since the noise current flows each time the transistors are switched on or off.
In addition to the main circuit of the inverter, the DC-to-DC switching power regulator (DC/DC converter), which is
the power source for the control circuit of the inverter, may be a noise source in the same principles as stated
above.
The frequency band of this noise is less than approximately 30 to 40 MHz. Therefore, the noise will affect devices
such as AM radios using low frequency band, but will not virtually affect FM radios and television sets using higher
frequency than this frequency band.
Figure A-1 Outline of Inverter Configuration
Converter part Inverter part
Power source
DC/DC
converter
Control circuit