Fuji Electric FRENIC-Ace series, User Manual

Page: 311 / 788

5.3 Description of Function Codes
5-141
FU
NCT
IO
N
C
O
DE
S
Chap 5
C21
C22 to C28
Pattern operation mode selection
Stage 1 to 7 / Timed operation
Pattern operation is a function of automatic operation according to the predefined run time, rotational direction,
acceleration/deceleration time and reference frequency.
When using this function, set the frequency setting (F01) to 10 (pattern operation).
The following operation patterns are available:
C21:Setting Operation pattern
0 Pattern operation performed for one cycle and stopped after the cycle.
1 Pattern operation repeatedly performed and immediately stopped with a stop command
2 Pattern operation performed for one cycle and operation continued at the reference
frequency after the cycle.
3 Timed operation
■
C22 to C28 Stage 1 to Stage 7
Specify the run time for Stage 1 to Stage 7.
Press the
key three times for each function code to set the following three data.
Setting Description
1st Specifies the run time between 0.0 and 6000 s.
2nd 2nd: Specifies the rotational direction F (forward) or r (reverse)
3rd 3rd: Specifies the acceleration/deceleration time between 1 and 4.
1: F07/F08
2: E10/E11 3: E12/E13 4: E14/E15
If the
key is pressed to exit the function code before the three data are specified by pressing the key three
times, no data are updated.
For any unused stage, specify 0.0 as the run time. The stage is skipped and the next stage becomes ready for
setting.
Time
Time
Reverse
direction
Time
Setting value: 0
0
Forward
direction
Output
frequency
Reverse
direction
1 cycle completed
Setting value: 1
0
Forward
direction
Output
frequency
Reverse
direction
1 cycle completed
Setting value: 2
0
Forward
direction
Output
frequency
1 cycle completed
Run command
source
Run command
source
Run command
source
2 cycle completed
2 cycles completed